Every standalone tool (eeschema, pcbnew, calculator) boots through
common/single_top.cpp, which runs STARTWIZARD::CheckAndRun() — the first-run
"KiCad Setup" wizard. It shows whenever any provider (SETTINGS / LIBRARIES /
PRIVACY) reports NeedsUserInput(), which is always true on our ephemeral MEMFS
with no config, and its modal loop crashes Asyncify. Only eeschema was seeding
config, so pcbnew and the calculator hit the wizard.
Flip TOOL_NEEDS_CONFIG_SEED to true for pcbnew and calculator so seedKicadConfig
runs in preRun for all three (it writes the kicad_common.json privacy flags and
the sym/fp/design-block lib-tables the providers check), making NeedsUserInput()
false and skipping the wizard. Verified in-browser: pcbnew renders a board at
/p/mytest/pcbnew/bottom.kicad_pcb and the calculator loads, both wizard-free.
Co-Authored-By: Claude Opus 4.8 (1M context) <noreply@anthropic.com>
Replace the same-origin iframe in WasmTool with a direct in-document boot
(src/wasm/boot.ts): build the global Emscripten Module + preRun steps and
inject wx.js + <tool>.js into the page, the same artifacts the e2e harness
uses. The build is non-modularized (global Module/FS) and pthread-based, so
locateFile/mainScriptUrlOrBlob are set so the wasm + worker load regardless
of the SPA route, and only one tool runs per page load.
Two bugs found during in-browser verification:
- This build does not export Module.FS (touching it aborts); use the global
window.FS like the harness does.
- The wasm reads top-level frame geometry from a global `mainWindow`
(offsetWidth/offsetHeight/offsetTop), falling back to a hardcoded 1280x720
when undefined. The harness sets it via `var mainWindow = ...`; we must too,
or the frame mismatches the viewport and the whole AUI layout breaks
(missing toolbars, transparent/ghosted panels). Expose the #main-window
element as window.mainWindow.
Verified: eeschema renders the full UI (menus, toolbars, panels, schematic)
matching the e2e baseline. pcbnew remains pre-existing-broken at the build
level (raw pcbnew.html harness is equally broken: empty registry, dynCall
"ii signature" errors), independent of this change.
Co-Authored-By: Claude Opus 4.8 (1M context) <noreply@anthropic.com>
- inject-dyncall-shims.sh: add a dynCallLegacy -> wasmExports fallback so embind's
generic dynCall path finds the DYNCALLS=1 trampolines. Without it, an Asyncify
unwind/rewind through an embind call (kicadOpenFile -> OpenProjectFiles) died
with "f is not a function".
- open-flow.ts: kicadOpenFile runs OpenProjectFiles under Asyncify, so its sync
return is a falsy placeholder. Invoke it and poll the frame title for the load
instead of trusting the return value, and never fall back to UI automation
while the hook is in flight (it would re-enter the suspended Asyncify call).
- .gitignore: ignore .playwright-mcp scratch.
- bump kicad + wxwidgets submodules to the wasm schematic-open fixes.
Co-Authored-By: Claude Opus 4.8 (1M context) <noreply@anthropic.com>
